TM 10-3990-205-12&P
3-6 REPLACE TWIST LOCK ACTUATING COMPONENTS - CONT
-
CONT
Remove the nuts (6). lockwashers (7), capscrews (8), and bearing (9).
3.
Remove the pin (10) from bar (11).
4.
Repeat the above procedures and remove the corresponding parts on the opposite
5.
side of the spreader.
Remove the bar (11) and cams (12).
6.
Insert the bar (11) through one side of the spreader frame (13), and slide the
1.
two cams (12) onto the bar (11). Position the bar (11) in the holes on each side
of the spreader frame (13).
Slide the cam (12) into position on the bar (11) and install the pin (10).
2.
Place the bearing (9) on the bar (11) and install the capscrews (8), lockwashers
3.
(7), and nuts (6).
Position the twist lock actuating cam (2) on the end of the bar (11) and install
4.
the pin (1).
Lubricate the grease fittings (14) with grease, MIL-G-10924, using a grease
1.
gun.
Lubricate the clevis pins (4) by hand with grease MIL-G-10924.
2.
3-7 REPLACE CONTROL CABLES
This task covers:
a. Removal
b. Installation
General Safety Instructions
Tools
Tool Kit, General Mechanics: Auto
The spreader shall be firmly
Materials/Parts
supported on timbers or blocks
Cable, MIL-W-8342C-72
to prevent possible injury
Cable, MIL-W-8342C-96
to personnel.
Change 1
3-13