TM 5-3895-367-14&P
(26)
Inside hopper, adjust position of center bearing
(21) so that agitator pipes (8 and 20) will not
scrape inside of hopper, then fully tighten all
mounting hardware to 60 lb-ft.
(27)
Install agitator drive chain (para 4-38). Before
installing chain guard, adjust position of bearing
(46) to put tension on chain, then fully tighten
bearing mounting hardware to 60 lb-ft. Install
chain guard.
FOLLOW-ON MAINTENANCE:
Lubricate agitator bearings and clutch (Chapter 3,
Section I).
Stow operators platform in hopper (para 4-14).
5-5. FEED ROLL REPLACEMENT.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
Reference
Repair: Field Maintenance, Basic, Less Power
Para 4-18 Rear bracket removed from transport
truck.
Materials/Parts:
Para 4-39
Feed roll drive chain removed.
One locknut
Para 4-40
Balance roller removed.
Eight lockwashers
Personnel Required: Three
5-23