TM 5-3895-367-14&P
4-11.
REMOVING AND INSTALLING TAILLIGHTS (CONT).
(3)
Along front of spreader, loosen screws (6) in four
C-clamps (7) and remove harness (2) from C-
clamps.
(4)
On left side of spreader, loosen screw (8) in C-
clamp (9) and remove harness (2) from C-
clamp.
(5)
Loosen thumbscrew (10) and remove taillight
(11) and bracket (12) from holder (13).
(6)
Loosen thumbscrew (14) and pull out balancing
handle (15).
(7)
Loosen thumbscrew (16) and remove taillight
(17). Remove two taillights and harness from
spreader. Retain for storage on transport truck.
(8)
Push In balancing handle (15) and tighten
thumbscrew (14).
(9)
Remove transport truck and tongue from
spreader (para 4-12).
b.
Installation.
(1)
Loosen thumbscrew (14) and slide balancing
handle (15) out several inches to keep it from
interfering with left taillight (17). Tighten
thumbscrew.
(2)
Slide right taillight bracket (12) into holder (13)
and tighten thumbscrew (10).
(3)
Route harness (2) through C-clamp (9) and
tighten screw (8) in C-clamp.
(4)
Slide left taillight bracket (18) into holder (19)
and tighten thumbscrew (16).
(5)
Along front of spreader, route harness (2)
through four C-clamps (7) and tighten screws (6)
in C-clamps.
(6)
On right side of spreader, route harness
(2) through C-clamp (5) and tighten screw (4) in
C-clamp.
(7)
Secure harness (2) to lift bar (3) using
tiedown strap (1).
4-10
