3-4 REPLACEMENT OF GUIDE WHEEL ASSEMBLY COMPONENTS - CONT
Remove and discard the cotter
pin (3). Remove the shouldered
shaft (4), and remove the guide
wheel (2) and bearing (5) as an
Remove the nuts (6), lockwash-
ers (7), and capscrews (8). to re-
move mounting bracket (1).
If the bearing (5) requires replacement,
remove the bearing and install a new
bearing (5) in the guide wheel (2).
If the guide wheel (2) requires
replacement, install a new
Position the mounting bracket (1) on the twist lock housing (9), and install the
Position the guide wheel (2) in the mounting bracket (1), and install the shouldered
shaft (4) and a new cotter pin (3).
3-5 SWING BOLT AND/OR CONTROL ROD REPLACEMENT
This task covers:
Tool Kit, General Mechanics: Auto
ROD, 214A-39 F20 or
ROD, 215A-39 F40