TM 10-3990-205-12&P
3-8 REPLACE ALIGNMENT ARM AND COMPONENTS - CONT
- CONT
INSTALLATION
Position the alignment arm (9) between the mounting brackets (13 and 14).
e.
Insert the pivot pin (12) through the top hole in the mounting bracket (13),
the center holes in the alignment arm (9). and through the top hole in the
mounting bracket (14).
Install the pin (15) in the pivot pin (12).
f.
Slide the spring pin assembly (16) into the bottom hole in the mounting
g.
bracket (14), the bottom holes in the alignment arm (9), and the bottom
hole in the mounting bracket (13). until the spring stop (16) contacts the
mounting bracket (14).
Slide the spring (18) onto the spring pin assembly (16) until it contacts the
h.
spring stop (17).
Compress the spring (18) as necessary to position the bracket (19) on the
i.
spring pin assembly (16) and frame (2). Install the capscrews (20), lockwash-
ers (21), and nuts (22).
Refer to Paragraph 3-7 for procedures and install the cable assembly (23).
j.
LUBRICATION
Lubricate the pivot pin (12) and spring pin assembly (16) by hand with grease MIL-G-
10924.
3-9 REPLACE SLING ASSEMBLY COMPONENTS
c. Installation
a. Inspection
This task covers:
b. Remove
INITIAL SETUP
General Safety Instructions
Tools
Tool Kit, General Mechanics: Auto
Materials/Parts
The spreader shall be firmly
supported on timbers or blocks
Shackle, AN 116-24
Wire Rope Assembly.
to prevent possible injury to
214A-33 or 215A-33
personnel.
Lifting Ring, 214A-67 or 215A-67
3-19
Change 1