TM 5-3895-367-14&P
4-12.
REMOVING AND INSTALLING TRANSPORT TRUCK AND TONGUE (CONT).
(8)
Roll transport truck (26) underneath spreader
with higher side of transport truck to rear of
spreader.
(9)
Lower spreader onto transport truck (26).
Continue to support spreader with lifting device.
NOTE
•
Do not fully tighten any transport
truck mounting hardware until instructed to
do so.
•
Shorter mounting screws are used on
rear of transport truck. Longer mounting
screws are used at front of transport truck.
(10)
At rear of spreader, Install two shorter screws
(25), new lockwashers (24), and nuts (23) to
secure rear of spreader to transport truck (26).
WARNING
Do not put hands in between
spreader and transport truck while
spreader is suspended. Failure to
follow this warning could result in
injury.
(11)
At front of spreader, install two longer screws
(33), spacers (34) (if equipped), new
lockwashers (32), and nuts (31) to secure front
of spreader to transport truck (26). Tighten
screws until welded spacer (55) is flush with
bracket (56).
(12)
Secure bracket (30) to spreader using screw
(29), new lockwasher (28), and nut (27).
4-16
