TM 5-3895-367-14&P
(4)
If equipped, remove four bolts (6) and nuts (7)
from rear crossmember of dump truck.
(5)
Remove four 8-1 in. mounting bolts (8) from
spreader toolbox.
(6)
Install truck hitch (4) and two spacers (9) on rear
crossmember of dump truck using four bolts (8),
flatwashers (2), new lockwashers (5), and nuts
(1). Tighten truck hitch mounting bolts to 60 lb-
ft.
(7)
Fully loosen bolt (10) In each C-clamp (11) on
chute (12).
(8)
Remove outer nut (13) and flatwasher (14) from
each bolt (15) welded to chute (12). Do not
remove Inner nuts from bolts.
(9)
Remove two nuts (16), four flatwashers (17 and
18), and two bolts (19) from chute (12).
(10)
Position chute (12) for installation on dump truck.
Ensure that bolts (15) welded to chute enter
brackets (20) behind tire flaps (21).
(11)
Install bolt (19) through chute (12) and bracket
(22). Secure bolt using large flatwasher (18),
small flatwasher (17), new lockwasher (23), and
nut (16).
(12)
Repeat step (11) on other side of chute (12).
(13)
Install flatwasher (14), new lockwasher (24), and
nut (13) on each of the two bolts (15) welded to
chute (12).
(14)
Tighten bolt (10) In each C-clamp (11) on chute
(12).
(15)
Install operator’s platform on spreader (para 4-
14).
4-21
