TM 5-3895-367-14&P
(6)
Install front angle (18) on wheel bearing
support (27) using two screws (26), new
lockwashers (25), and nuts (24). Repeat for
rear angle (16).
(7)
Secure rear angle (16) to outside angle (17)
using two screws (15), new lockwashers (14),
and nuts (13). Repeat for front angle (18).
(8)
Secure front angle (18) to inside angle (23)
using two screws (21), flatwashers (22), new
lockwashers (20), and nuts (19). Repeat for
rear
angle
(16).
(9)
Fully tighten all gearbox mounting hardware
to 60 lb-ft.
(10) Fully tighten all bracket mounting hardware to
60 lb-ft.
(11) Secure bracket (6) to throwout shaft (7) using
screw (5), new lockwasher (4), and nut (3).
(12) Install nipple (12) in gearbox (2).
(13) Install elbow (11) on nipple (12).
(14) Install nipple (10) in elbow (11).
(15) Install elbow (9) on nipple (10).
(16) Install pipe plug (8) In elbow (9).
FOLLOW-ON MAINTENANCE:
•
Install traction drive wheels (para 4-41).
•
Install feed roll drive chain and sprocket (para 4-
39).
•
Lubricate gearbox (Chapter 3, Section I).
4-61
