TM 5-3895-367-14&P
4-40. BALANCE ROLLER REPAIR.
This task covers:
a.
Removal
d.
Assembly
b.
Disassembly
e.
Installation
c.
Cleaning and Inspection
INITIAL SETUP
Tools:
Personnel Required: Two
Tool Kit, General Mechanic’s Automotive
Equipment Conditions:
Torque wrench
References
Materials/Parts:
Para 4-15
Spreader uncoupled from dump truck.
Dry cleaning solvent (Item 11, Appendix E)
Twelve lockwashers
b. Disassembly.
WARNING
(1)
Remove setscrew (7) from each mounting
Balance roller weighs 50 lb. If needed, use assis-
bracket (8). Drive shaft (9) out of mounting
tance when removing balance roller. Failure to fol-
brackets.
low this warning could cause injury.
(2)
Remove three nuts (10), lockwashers (11),
and screws (12) securing each mounting
a. Removal. Remove six nuts (1), lockwashers (2),
bracket (8) to mounting plate (4). Remove
and screws (3) securing balance roller mounting plate (4)
mounting brackets from mounting plate and
to wheel bearing supports (5). Remove balance roller and
remove roller (13) from mounting brackets.
two brackets (6). Discard lockwashers.
Discard lockwashers.
4-64
