TM 10-3990-205-12&P
Table 3-1. Troubleshooting - CONT
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
SLING ASSEMBLY, WIRE ROPE OR SHACKLES WORN OR DAMAGED
Inspect wire rope and shackles for excessive wear, or extent of
Step 1.
damage.
Notify unit maintenance of the extent of wear or damage.
ONE OR MORE TWIST LOCKS DO NOT ROTATE FROM UNLOCKED TO
LOCKED POSITION, OR FROM LOCKED TO UNLOCKED POSITION, WHEN
THE CONTROL CABLE IS PULLED.
Operate the twist locks by pulling the control cable, and deter-
Step 1.
mine which twist locks are not operating properly.
Notify unit maintenance of the malfunction.
Inspect the control rods for bends or other malfunctions.
Step 2.
Notify unit maintenance of any unserviceable control
rods.
Section III. MAINTENANCE PROCEDURES
3-3 REPLACEMENT OF TWIST LOCK ASSEMBLY COMPONENTS
c. Installation
a. Removal
This task covers:
d. Lubrication
b. Inspection
Materials/Parts - continued
D-Washer Flat - 214A-43
Tools
Grease, MIL-G-10924
Tool Kit, General Mechanics: Auto
General Safety Instructions
NSN
Shop Equipment, Auto
Maint: Org. Maint, Commons
N0. N S N 4 9 1 0 - 0 0 - 7 5 4 - 0 6 5 4
The spreader shall be firmly
Materials/Parts
supported on timbers or blocks
to prevent possible injury
Shaft, Coupling
Half - 214A-3
to personnel.
Rod, Cam Lock
- 214A-46
Cam, Twistlock
Locking - 214A-38
Cam, Twistlock
- 214A-7
3-4
