TM 5-3895-367-14&P
5-4. AGITATOR REPAIR (CONT).
(9)
Install lubrication fitting (72) in bearing (46).
(10)
Install lubrication fitting (71) in each clutch (51
and 54).
e.
Installation.
(1)
If necessary, install left angle (64) on wheel
bearing support using two screws (70), new
lockwashers (69), and nuts (68). Tighten
angle mounting screws to 60 lb-ft. Install right-
hand traction drive wheels (para 4-41).
(2)
Install right angle (60) on side of hopper using
screw (67), new lockwasher (66), and nut (65).
Install screw through upper mounting hole in
right angle. Tighten angle mounting screw to
60 lb-ft.
(3)
Install bracket (41) on left angle (64) using two
screws (63), new lockwashers (62), and nuts
(61). Tighten bracket mounting screws to 60
lb-ft.
(4)
Secure bracket (41) to right angle (60) using
two screws (59), new lockwashers (58), and
nuts (57). Tighten bracket mounting screws to
60 lb-ft.
(5)
Install key (55) and clutch (54) on traction drive
axle (56). Tighten setscrew (53).
(6)
Install drive shaft (34) in bearing (46).
(7)
Slide two collars (49 and 50) and clutch (51)
onto drive shaft (34). Do not tighten setscrews
(47 and 48) or install keys (52) at this time.
(8)
Install bushing (46), drive shaft (34), clutch
(51) and two collars (49 and 50) as a unit on
right side of spreader using three screws (45),
new lockwashers (44), and nuts (43). Do not
fully tighten mounting hardware at this time.
(9)
Install two keys (52) in drive shaft (34) then
slide clutch (51) over keys.
(10)
Slide collar (50) against bushing (46) and
tighten setscrew (48).
(11)
Install fork (38) over clutch (51). Secure fork
to bracket (41) using screw (40), flatwasher
(42), and new locknut (39). Do not fully tighten
locknut, fork must be free to pivot.
(12)
Install clutch shift rod (37) through right side of
hopper and secure to fork (38) using
flatwasher (36) and new cotter pin (35).
(13)
Hold fork (38) in vertical position and slide
collar (49) against clutch (51). Tighten
setscrew (47) in collar.
(14)
Check operation of clutch before continuing.
Clutch shift rod (37) must engage and
disengage clutch halves (51 and 54) without
excessive force. Ensure that clutch halves
fully disengage when clutch shift rod is pulled
out. If necessary, adjust position of collar (49).
5-20
