TM 5-3895-367-14&P
(15)
Install key (33) and sprocket (32) on drive
shaft (34). Tighten two setscrews (31).
(16)
Inside hopper, install bearing hanger (29) on
center gusset (30) using screw (28), flatwasher
(27), new lockwasher (26), and nut (25). Do not
fully tighten mounting hardware at this time.
(17)
Install new lockwasher (23) and nut (22) on
square neck bolt (24) to secure bearing hanger
(29) to center gusset (30). Do not fully tighten at
this time.
(18)
Install bushing (9) in center bearing (21).
Note
Right-hand side of agitator pipe assembly has
hole in end coupling for mounting sprocket; left-
hand side does not. Ensure that you install the
correct side of pipe assembly in the correct
place.
(19)
Install right-hand side of agitator pipe assembly
(20) through right side of spreader.
(20)
Inside hopper, secure right side of agitator pipe
assembly (20) to bushing (9) using screw (19)
and new locknut (18).
5-21