TM 5-3895-367-14&P
4-13.
INSTALLING AND REMOVING TRUCK HITCH (CONT).
b.
Removing Truck Hitch from Dump Truck.
NOTE
If spreader was used with M929A1,
M929A2, M930A1, or M930A2 dump
truck, perform steps (1) through (9)
and (12). If spreader was used with
M51A2, M817, M929, or M930 dump
truck, perform steps (10) through
(13).
(1)
Loosen bolt (10) in each C-clamp (11) on chute
(12).
(2)
Remove two nuts (16), lockwashers (23), four
flatwashers (17 and 18), and two bolts (19)
securing chute (12) to brackets (22). Discard
lockwashers.
(3)
Remove outer nut (13), lockwasher (24), and
flatwasher (14) from each of the bolts (15)
welded to chute (12). Do not remove inner nuts
from bolts. Discard lockwashers.
(4)
Remove chute (12) from dump truck bed.
(5)
Stow chute mounting hardware on chute (12).
(6)
Remove four nuts (1), lockwashers (5),
flatwashers (2), and bolts (8) securing truck hitch
(4) and two spacers (9) to rear crossmember of
dump truck. Remove truck hitch and two
spacers. Discard lockwashers.
(7)
Stow four 8-1/2 in. mounting bolts (8) In
spreader toolbox.
4-22
