TM 5-3895-367-14&P
NOTE
Step (4) is for gearbox side of spreader
only.
(4)
Loosen setscrew (2) in clutch (3). Slide
clutch toward gearbox (4).
NOTE
Step (5) is for agitator control clutch
side of spreader only.
(5)
Loosen setscrew (5) in bearing (6). Slide
bearing toward clutch (7).
(6)
Loosen two setscrews in each bearing (8).
(7)
Loosen setscrew in each hub (9).
(8)
Slide tires (10) toward outside of spreader.
(9)
Tighten setscrew in each hub (9).
(10)
Slide tires (10) toward center of hopper to
free shaft (11) from gearbox clutch or
agitator clutch bearing.
(11)
Check clearance at outer end of shaft (11).
If clearance is not sufficient to allow traction
wheels to be removed, repeat steps (7)
through (10).
(12)
Wrap lifting sling or chain around shaft (11)
in between tires (10). Connect lifting sling or
chain to lifting device and take up slack.
(13)
Remove two nuts (12), lockwashers (13),
screws (14), and flatwashers (15) securing
each bearing (8) to bearing supports (16).
(14)
Using lifting device, remove shaft (11) and
tires (10) from spreader and rest on ground.
Remove lifting slings or chains from shaft.
4-67
