TM 5-3895-367-14&P
14-41. TRACTION WHEEL ASSEMBLY REPAIR (CONT).
NOTE
NOTE
Step (4) is for gearbox side of spreader only.
Step (5) Is for agitator control clutch side of
spreader only.
(4)
On gearbox side of spreader, slide shaft (11)
Into clutch (3), then tighten setscrew (2) In
(5)
On agitator clutch control side of spreader,
clutch (3) and two setscrews In each bearing
adjust position of shaft (11) so that bearing (6)
(8). Center tires (10) in opening, then tighten
and clutch (7) are disengaged when agitator
setscrew In each hub (9).
clutch control lever is pushed in and engaged
when agitator clutch control lever is pulled
out. Tighten setscrew (5) in bearing (6), then
tighten two setscrews In each bearing (8).
Center tires (10) in opening, then tighten
setscrew in each hub (9).
(6)
Check tire rotation. Tires should rotate freely.
If necessary, adjust position of bearings (8)
until tires rotate freely.
4-70
