TM 5-3895-367-14&P
14-41. TRACTION WHEEL ASSEMBLY REPAIR (CONT)
b. Disassembly.
(1)
Remove bearing (8) and spacer (17) from
each end of shaft (11). If necessary,
remove two setscrews (18) from each
bearing.
(2)
Loosen setscrew (19) in each hub (9).
(3)
Remove shaft (11) from two hubs (9).
Spacer (20) will come off with shaft.
(4)
Remove two keys (21) and woodruff key
(22) from shaft (11).
(5)
Deflate tire. Remove eight nuts (23),
lockwashers (24), and screws (25) securing
hub (9) to rims (26). Remove hub. Discard
lockwashers. Repeat for other wheel.
(6)
Remove lubrication fitting (27) from each
bearing (8).
c. Cleaning and Inspection.
WARNING
Dry cleaning solvent P-D-680 is toxic
and flammable. Wear protective
goggles, face mask, and gloves and
use in a well ventilated area. Avoid
contact with skin, eyes, and clothes
and do not breath vapors. Do not use
near open flame or excessive heat. The
flash point for Type I solvent is 100
degrees F (38 degrees C). The flash
point for Type II solvent is 140 degrees
F (60 degrees C). If you become dizzy
while using cleaning solvent, get fresh
air Immediately and get medical aid. If
contact with eyes Is made, wash your
eyes with water and get medical aid
immediately.
(1)
Clean all metal parts with dry cleaning
solvent and dry thoroughly.
(2)
Inspect all parts for cracks, damage, or other
defects. Replace all cracked, damaged, or
defective parts.
(3)
Refer to TM 9-214 for bearing cleaning and
inspection procedures.
(4)
Refer to TM 9-2610-200-14 for tire
Inspection, disassembly, repair, and
assembly procedures.
4-68
