TM 5-3895-367-14&P
5-2. COUPLER HITCH AND CRANK REPAIR (CONT).
a.
Removal.
(1)
Remove locknut (1), spacer (2), and bolt (3)
securing
bar
assembly
(4)
to
upper
pantograph links (5). Discard locknut.
WARNING
Bar assembly will be unsupported when mounting screws
are removed. Use assistance when removing bar
assembly. Failure to follow this warning could cause injury.
(2)
Remove ten nuts (6), lockwashers (7), and
screws (8) securing two spacer plates (9),
two spacer guides (10), and bar assembly (4)
to spreader. Remove plates, guides, and bar
assembly. Discard lockwashers.
(3)
Remove nut (11), lockwasher (12), and screw
(13) securing hitch adjusting crank (14) to
universal joint (15). Remove hitch adjusting
crank from left side of spreader. Discard
lockwasher.
(4)
Remove locknut (16), bolt (17), and spacer
(18) securing lower pantograph links (19) to
coupler support bracket (20) and coupler
angle (21). Remove pantograph links, screw
(22), nut housings (23), and universal joint
(15) as an assembly. Discard locknut.
5-2
