TM 5-3895-367-14&P
NOTE
Nut housings are tapped for right-hand
and left-hand threads. Ensure that nut
housings are installed in proper
location on adjusting screw.
(4)
Screw nut housings (23) onto adjusting
screw (22). Remove tags.
NOTE
Upper pantograph links have one large
hole and one small hole. Lower
pantograph links have two holes the
same size. Install upper pantograph
links on nut housing using smaller
hole.
(5)
On one nut housing (23), install one lower
pantograph link (19) on each end, then
install one upper pantograph link (5) on each
end. Secure to nut housing using two
flatwashers (33) and new cotter pins (32).
(6)
On other nut housing (23), install one upper
pantograph link (5) on each end, then install
one lower pantograph link (19) on each end.
Secure to nut housing using two flatwashers
(33) and new cotter pins (32).
(7)
Install lubrication fitting (31) in universal joint
(15).
(8)
Install universal joint (15) on adjusting screw
(22) using screw (30), new lockwasher (29),
and nut (28).
e. Installation.
(1)
Install coupler angle (21) on bearing support
brackets (27) using four screws (26), new
lockwashers (25), and nuts (24). Tighten
coupler and mounting bolts to 60 lb-ft.
5-5
