TM 5-3895-367-14&P
5-3.
GEARBOX REPAIR (CONT).
(13) Position thrust washer (33) and clutch gear
(34) in gearbox (5) then install drive shaft (30) through side
of gearbox into clutch gear.
(14) Slide clutch (35) onto drive shaft (30).
(15) Slide spur gear (29) onto drive shaft (30).
(16) Position idler gear (12) and thrust washer (32)
in gearbox (5).
(17) Install shaft (31) through idler gear (12) and
thrust washer (32) into gearbox (5). Ensure
that idler gear (12) properly engages forward
spur gear (23) after shaft is installed.
(18) Install plate (27) and new gasket (28) on
gearbox (5) using four screws (25) and new
lockwashers (26). Tighten plate mounting
screws to 60 lb-ft.
(19) Secure idler support bracket (18) to shaft (31)
using screw (10) and new lockwasher (11).
Do not tighten screw.
(20) Secure idler support bracket (18) to gearbox
(5) using two screws (16), new gaskets (17),
new lockwashers (15), and nuts (14). Tighten
support bracket mounting screws to 25 Ib-ft,
then tighten screw (10).
(21) Install two pipe plugs (13) in bottom of
gearbox (5).
5-12
