TM 5-3895-367-14&P
(22) Install clamp (39) around clutch (35) using
two screws (38), new lockwashers (37), and
nuts (36). tighten clamp mounting screws to
14 lb-ft.
(23) Install bellows (42) in gearbox (5) and secure
with wire (41).
(24) Install fork (9) over clamp (39).
(25) Install throwout shaft (8) through gearbox (5)
and bellows (42). Secure throwout shaft to
fork (9) using new cotter pin (7).
(26) Install drain plug (43) in bottom of gearbox
(5).
NOTE
Before installing gearbox cover, check gearbox for proper
operation. Ensure that all gears turn freely and properly
engage In both forward and reverse. Ensure that clutch
slides freely on drive shaft and throwout shaft engages and
disengages clutch without requiring excessive force.
(27) Place new gasket (4) and cover (3) on
gearbox
(5)
then
install
upper,
middle
gearbox mounting screw (6).
(28) Secure cover (3) to gearbox (5) using 12
screws (1) and new lockwashers (2). Tighten
cover mounting screws to 25 Ib-ft in a cross
pattern.
FOLLOW-ON MAINTENANCE:
•
Install gearbox (para 4-37).
•
Lubricate gearbox (Chapter 3, Section 1).
5-13
