TM 5-3895-367-14&P
(7)
Remove cotter pin (12) from handle
(13).Remove handle, flatwasher (14)and
spring (15) from gate (5). Discard cotter
pin.
NOTE
Steps (8) through (11) are for left-hand
frame sup- port and rail.
(8)
Remove
two
quick-release
pins
(16)
securing rail (17) to frame support (18).
(9)
Pull rail (17) up and out of frame support
(18). Support bracket (19) will come off
with rail.
(10)
Remove quick-release pin (20) securing
support bracket (19) to rail (17). Remove
support bracket from rail.
NOTE
All
of
the
quick-release
pins
are
removed the same way. Step (11) is for
one quick-release pin. Repeat as
necessary for the other quick-release
pins.
(11)
Remove
screw
(21)
securing
quick-
release pin (16) to frame support (18).
Remove quick-release pin.
(12)
Loosen setscrew (22) and remove pipe
(23) from each housing (24).
b.
Cleaning and Inspection.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable.
Wear protective goggles, face mask, and gloves and use
in a well ventilated area. Avoid contact with skin, eyes,
and clothes and do not breath vapors. Do not use near
open flame or excessive heat. The flash point for Type I
solvent is 100 degrees F (38 degrees C). The flash point
for Type II solvent is 140 degrees F (60 degrees C). If
you become dizzy while using cleaning solvent, get fresh
air immediately and get medical aid. If contact with eyes
is made, wash your eyes with water and get medical aid
immediately.
(1)
Clean all parts with dry cleaning solvent
and dry thoroughly.
(2)
Inspect all parts for cracks, breaks, or
other damage. Replace all damaged
parts.
c.
Assembly.
(1)
Install pipe (23) In housing (24) and
tighten setscrew (22). Repeat for other
side.
4-39
