TM 5-3895-367-14&P
c. Assembly.
(1)
Slide collar (15) onto shaft (4) to position
(5)
With feed roll control lever (3) set to FOR-
recorded in disassembly step (3). Tighten two
WARD SPREAD, rotate traction tires in a
setscrews (16)
reverse direction or push spreader backward.
Gearbox should disengage and feed roll
(2)
Install flatwasher (14), spring (13), bracket
should stop turning.
(8), spring (12), flatwasher (11), and new
(6)
Set feed roll control lever (3) to REVERSE
locknut (10) on shaft (4). Tighten locknut to
SPREAD. Rotate traction tires in a reverse
position recorded in disassembly step (1).
direction or push spreader backward. Ensure
that feed roll tums.
(7)
With feed roll control lever (3) set to REVERSE
SPREAD, rotate traction tires in a forward
d
Installation
(1)
Working from center of spreader, slide sh ift
direction or pull spreader forward. Gearbox
arm into position. Ensure that bracket (8)
should disengage and feed roll should stop
engages throwout shaft (9).
turning.
(2)
Install screw (7), new lockwasher (6), and nut
(8)
If any of the checks In steps (4) through (7)
(5) to secure bracket (8) to throwout shaft (9).
fail, adjust position of collar (15) and locknut
(10) on shaft (4). If gearbox will not engage,
(3)
Secure feed roll control lever (3) to shaft (4)
increase tension on springs (12 and 13). If
using screw (2) and new locknut (1).
gearbox will not disengage, decrease ten-
(4)
Set feed roll control lever (3) to FORWARD
sion on springs. Repeat steps (4) through (7)
SPREAD. Rotate traction tires or pull spreader
until clutch shift arm is properly adjusted.
forward. Ensure that feed roll turns.
until clutch shift arm
4-49
