TM 5-3895-367-14&P
4-29. FEED ROLL CONTROL LEVER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools:
Equipment Conditions:
Tool Kit, General Mechanic’s Automotive
References:
Materials/Parts:
Para 4-15
Spreader uncoupled from dump truck.
Two locknuts
a.
Removal.
(1)
Remove
locknut
(1)
and
screw
(2)
securing feed roll control lever (3) to shaft
(4). Discard locknut.
(2)
Remove
locknut
(5)
and
screw
(6)
securing feed roll control lever (3) to
quadrant (7). Discard locknut.
(3)
Squeeze grip (8) to release plunger
assembly (9). Remove feed roll control
lever (3) from spreader.
b.
Installation.
(1)
Squeeze grip (8) to release plunger
assembly (9). Position feed roll control
lever (3) for installation.
(2)
Secure feed roll control lever (3) to
quadrant (7) using screw (6) and new
locknut (5).
(3)
Secure feed roll control lever (3) to shaft
(4) using screw (2) and new locknut (1).
(4)
Check feed roll control lever (3) for proper
operation. If feed roll control lever does
not securely lock on quadrant (7), slightly
unbend loop at one end of wire (10) to
increase tension on plunger assembly (9).
4-47
