TM 10-3990-205-12&P
3-5 SWING BOLT AND/OR CONTROL ROD REPLACEMENT - CONT
Install the nut (9) on the
1.
swing bolt (2) and screw the
swing bolt (2) into the control
rod (8).
Install the nut (10) on the
2.
swing bolt (6) and screw the
swing bolt (6) into the control
rod (8).
NOTE
Inspect the clevis pin (3)
for excessive wear before
installing the control rod
assembly. Refer to Paragraph
3-3 for procedures to replace
the clevis pin (3).
Place the swing bolt (2) on
1.
the clevis pin (3) and install
a new cotter pin (1).
Position the swing bolt (6)
2.
on
the
cam
(7)
and
install
the clevis pin (5). Place the
swing bolt (11) on the clevis
pin (5) and install a new cotter
pin (4).
Lubricate the grease fittings (12) with grease MIL-G-10924 using a grease gun.
1.
Lubricate the clevis pins (3 and 5) by hand, with grease ML-G-10924.
2.
Pull the control cable (14) to move the twist lock (13) to the DISENGAGE position.
1.
Visually check the twist lock (13) to see if it is aligned with the twist lock guide
2.
on the bottom of the twist lock housing (15).
