TM 10-3990-205-12&P
3-5 SWING BOLT AND/OR CONTROL ROD REPLACEMENT - CONT
- CONT
8.
Check the twist locks on all four corners of the spreader in both the ENGAGE
and DISENGAGE positions, and make any necessary adjustments.
NOTE
When a control rod assembly is installed, and adjustments
are completed, approximately the same number of threads
should be visible on the swing bolts in each end of the control
rod.
3-6 REPLACE TWIST LOCK ACTUATING COMPONENTS
c.
Lubrication
a.
Removal
This task covers:
b.
Installation
General Safety Instructions
Tools
Tool Kit, General Mechanics: Auto
NSN 5180-00-177-7033
The spreader shall be firmly
Materials/Parts
supported on timbers or blocks
to prevent possible injury
Cam, Outside Center, 214A-26
to personnel.
Cam, Inside Center, 214A-41
.
Bearing, Shaft, 1-inch Dia., SCJT-1
Bar, Metal, Center, 214A-40
Grease, MIL-G-10924
Remove the pin (1) and twist
1.
lock actuating cam (2).
Remove and discard the cotter
2.
pin (3). Remove the clevis pin
(4) to disconnect the control
rods (5).
3-12
