TM 10-3990-205-12&P
3-5 SWING BOLT AND/OR CONTROL ROD REPLACEMENT - CONT
- CONT
If
the
twist
lock
(13)
and
3.
guide are not aligned, loosen
the
nuts
(16
and
17),
and
turn the stop nut (18) a few
turns into the bracket (19).
Rotate the control rod (8)
in the direction necessary
to bring the twist lock (13)
and guide into alignment.
Tighten the nuts (9 and 10).
4.
5.
Check to see that the cam
(7)
is
in
contact
with
the
stop bolt (18). If necessary,
loosen the nuts (16 and 17) and
turn the stop bolt (18) until it
contacts the cam (7). Tighten
the nuts (16 and 17).
Pull the control cable (14)
6.
to rotate the twist lock (13)
to the ENGAGE position.
Check to see that the twist
7.
lock
(13)
has
moved
to
a
position 90 degrees to the
twist lock guide. If the twist
lock (13) is not in a position
90 degrees to the twist lock
guide, perform the following
procedures.
Loosen the nuts (20 and 21) and turn the stop bolt (22) a few turns into
a.
the bracket (23).
b.
Position the twist lock (13) at 900 to the twist lock guide.
Turn the stop bolt (22) until it contacts the cam (7).
c.
Tighten the nuts (20 and 21).
d.
Pull the control cable (14) to move the twist lock (13) to the DISENGAGE
e.
position.
Check to see that the twist lock (13) is aligned with the twist lock guide,
f.
and that the cam (7) is in contact with the stop bolt (18).
3-11